Remove/install taillamp, trunk lid - AR82.10-P-4915EC

MODEL 207 

MODEL 212.0/1 

Fig 1: Identifying Taillamp And Trunk Lid Remove/Install Components - Shown On Model 207.3

Courtesy of MERCEDES-BENZ USA

Illustrated on model 207.3 

Model 212.0/1, shown on inner left rear lamp unit (E3/1) with removed trunk lid panel 

Fig 2: Identifying Taillamp And Trunk Lid Remove/Install Components - Shown On Model 212.0/1

Courtesy of MERCEDES-BENZ USA

	Risk of injury  caused by fingers being jammed or pinched when removing, installing or aligning hoods, doors, trunk lid/rear-end door or sliding roof.	No parts of the body or limbs should be within the operating area when the components are moving.	AS00.00-Z-0011-01A
	Notes on sensor system for trunk lid opening/closing		AH80.61-P-0001-01A
	Remove/install
1	Remove bolts (1)	MODEL 207
2	Remove expansion clips (2)	Clip remover	Fig 3
3	Remove cover (3) from trunk lid and disconnect electrical connector (4)
4	Loosen trunk lid panel (5) until electrical connector (6) or electrical connector (12) is accessible
5.1	Disconnect electrical connector (6)	MODEL 207
5.2	Disconnect electrical connection (12)	MODEL 212.0/1
6	Unclip cover (8) at trunk lid and remove	MODEL 207
7.1	Unscrew nuts (7)	MODEL 207
7.2	Loosen nut (13) until bracket (14) detaches from trunk lid	MODEL 212.0/1 Do not unscrew nut (13) completely.
8	Remove inner left rear lamp unit (E3/1) or inner right rear lamp unit (E4/1)	Check seal (9) for signs of damage, replace if necessary. On model 212, check that mounting brackets (15) are seated correctly on trunk lid.
9	Install in the reverse order

Fig 3: Identifying Clip Remover (452 589 01 63 00)

Courtesy of MERCEDES-BENZ USA