Remove/install contact plate for cell phone holder (UPCI (UHI)) in the armrest - AR82.70-P-8919ECA
MODEL 207.3/4 as of 3/1/11 with CODE 386 (Convenience telephony)
| Remove/install | |||
| Information on preventing damage to electronic components due to electrostatic discharge | AH54.00-P-0001-01A | ||
| 1 | Remove center console (4) | AR68.20-P-2000CW | |
| 2 | Remove screw/bolt (2) for fastening of telephone console (1) at bottom on center console (4) | ||
| 3 | Unclip telephone console (1) along with contact plate (7) from center console (4) using long wedge (L) | ||
| Figure | |||
| 4 | Remove telephone console (1) along with contact plate (7) from center console (4) | ||
| 5 | Expose electrical wiring harnesses (10) at telephone console (1) | ||
| 6 | Remove bolt (5) | ||
| 7 | Unclip and remove contact plate (7) from swinging base (6) | In the event of damage to the catch hooks, the contact plate (7) must be replaced. |
|
| 8 | Remove screw/bolt (8) | ||
| 9 | Expose electrical wiring harnesses (10) on contact plate (7) (arrow b) and disconnect Bluetooth module (A34/7) from contact plate (7) | ||
| 10 | Turn swinging base (6) until cutout (arrow c) is visible in the axis of telephone console (1) and electrical wiring harnesses (10) for Bluetooth module (A34/7) can be routed through cutout (arrow c) in axis of telephone console (1) | ||
| 11 | Route electrical wiring harnesses (10) through axis of telephone console (1) | ||
| 12 | Remove Bluetooth module (A34/7) from telephone console (1) | ||
| 13 | Install in the reverse order |