Install and weld in longitudinal member front section - AR62.20-P-1260-07EW

MODEL 212, 218 

Fig 1: Installing Inner/Outer Front Longitudinal Member

Courtesy of MERCEDES-BENZ USA

1. Install inner front longitudinal member (1.1), fit and fix in place.
2. Inner front longitudinal member (1.1) SG «««««  (area D).

   Perform inert gas welding in intervals, allow to cool down in between to prevent heat distortion (area D).

3. Clean inner area of weld seam and coat with zinc dust paint.
4. Install outer front longitudinal member (1.2), fit and fix in place.
5. Outer front longitudinal member (1.2) SG «««««  (area F).

   Perform inert gas welding in intervals, allow to cool down in between to prevent heat distortion (area F).

6. Inner front longitudinal member (1.1) and outer front longitudinal member (1.2) RP __•__  (areas C and E).
7. Clean weld joints.
Fig 2: Installing Front End Bracket
Courtesy of MERCEDES-BENZ USA
8. Remove shavings.
9. Install front end bracket (2), fit and fix in place
10. Front end bracket (2) RP __•__  (areas G, H and I).