Remove/install rear door window lifter - AR72.12-P-1810EG
MODEL 212 with CODE (Z04) Light armoring
| Remove/install | |||
| Risk of injury caused by hands or feet being pinched or crushed when working on windshield or windows | Secure windows to prevent them from falling, use only the prescribed lifting tools, always wear safety shoes. | AS67.00-Z-0003-01A | |
| Notes on avoiding damage to windows installed in special high-security vehicles | AH67.00-P-0003-01FB | ||
| Information on preventing damage to electronic components due to electrostatic discharge | AH54.00-P-0001-01A | ||
| 1 | Completely open crank window (17). | ||
| 2 | Remove rear door lining | AR72.12-P-1010CW | |
| 3 | Disconnect electrical connection on left rear door (X35/3) and electrical connector on right rear door (X35/4) | ||
| 4 | Unclip grommets (2, 3) | ||
| 5 | Pull door wiring harness (1) out of rear door | ||
| 6 | Remove grommets (6, 7) from inner door panel (5) | ||
| 7 | Remove bolts (4) | *BA72.12-P-1006-01O | |
| 8 | Remove inner door panel (5) from rear door, simultaneously guide inside door handle Bowden cable and locking pin Bowden cable through | ||
| 9 | Unscrew bolt (8) | *BA72.12-P-1010-01O | |
| 10 | Remove guard plate (9) | ||
| 11 | Remove adhesive tape (10) over connector (11) from inner door panel (12) | ||
| 12 | Disconnect electrical connector (11) | ||
| 13 | Cut cable tie (13) | ||
| 14 | Remove grommet (14) from inner door panel (12) | ||
| 15 | Guide electrical wiring harness for left rear door power window motor (M10/5) or right rear door power window motor (M10/6) through inner door panel (12) | ||
| 16 | Unscrew nuts (15) | *BA72.12-P-1007-01O | |
| 17 | Move crank window (17) completely upward | ||
| 18 | Secure crank window (17) against falling down with clamping pliers | Fig 4 | |
| 19 | Unscrew bolts (18, 19) | *BA72.12-P-1011-01O | |
| 20 | Remove protective plate (20) from rear door | ||
| 21 | Unscrew nuts (22) | *BA72.12-P-1009-01O | |
| 22 | Remove bracket (23) | ||
| 23 | Carefully remove power window (24) from rear door | ||
| 24 | Install in the reverse order |
REAR DOOR
| Number | Designation | Model 212 with code Z04 | |
|---|---|---|---|
| BA72.12-P-1006-01O | Bolt, inner door panel to rear door | Nm | 5 |
| BA72.12-P-1007-01O | Nut, crank window to power window | Nm | 12 |
| BA72.12-P-1009-01O | Nut, power window to rear door | Nm | 25 |
| BA72.12-P-1010-01O | Bolt, protective plate to triangular window | Nm | 25 |
| BA72.12-P-1011-01O | Bolt, protective plate for beltline to door | Nm | 25 |