Electric wiring diagram for panoramic sliding roof - PE77.20-P-2200-97DAA
MODEL 212 with CODE 413 (Automatic panoramic sliding sunroof) Control unit A98
| Code: | Designation: | Position: |
|---|---|---|
| A0 | Color code key | 23L |
| A98 | Panoramic sliding roof control module | 3A |
| A98 | Panoramic sliding roof control module | 12A |
| A98b1 | Hall sensor 1, panoramic sliding roof | 14A |
| A98b2 | Hall sensor 2, panoramic sliding roof | 15A |
| A98m1 | Panoramic sliding roof motor | 13A |
| A98n1 | Panoramic sliding roof control unit | 9A |
| CAN B | Interior CAN | 7K |
| M12/5 | Panoramic sliding roof roller sun blind drive unit | 15L |
| M12/5b1 | Hall sensor 1, panoramic sliding roof roller sun blind | 16L |
| M12/5b2 | Hall sensor 2, panoramic sliding roof roller sun blind | 17L |
| M12/5m1 | Panoramic sliding roof roller sun blind motor | 18L |
| N10/1 | Front SAM control unit with fuse and relay module | 3L |
| N10/1f17 | Fuse 17 | 2L |
| N70/3 | Overhead control panel electronics | 11L |
| U12 | Valid for left-hand drive vehicles | 5G |
| U13 | Valid for right-hand drive vehicles | 5H |
| W15/1 | Right footwell ground point | 5K |
| W15/2 | Left footwell ground point | 5K |
| X204 | Panoramic sliding roof electrical connector | 1G |
| X30/32 | Left vehicle floor interior CAN voltage distributor electrical connector | 8L |