Apply bonding material to rear panoramic roof cover - AR77.21-P-0751-03EW
MODEL 204.3, 207.3, 212.0 with CODE (413) Panoramic glass roof with top sliding roof
REPAIR MATERIALS
| Number | Designation | Order number |
|---|---|---|
| BR00.45-Z-1089-02A | Repair kit, installing window, 1-component adhesive, replaced by: A 221 670 81 01 | A 221 670 21 01 |
Wear cotton gloves. Ensure that no fingerprints are present in the bonding surface (1) area. The bonding surface (1) must be free of dust, oil, grease, wax, contamination residues and other adhesive constituents to prevent adhesion problems when glazing.
- Cut triangular opening of application nozzle so that adhesive can be applied with a height of approx. 13 mm and a width of approx. 8 mm.
- Guide application nozzle along bonding surface (1) while uniformly pressing out adhesive. "Pressofix" cartridge gun.
Carefully remove adhesive residues immediately. Completely remove excess adhesive from cartridges immediately after applying adhesive and dispose of it as per local regulations. The length of the two adhesive beads should be approx. 60 mm.