LEMON Manuals: Even more car manuals for everyone
Home >> Mercedes Benz >> 2016 >> CLS400 Base >> Repair and Diagnosis >> External Pages >> Different car >> Section 224 (Rear Axle - 212 Chassis - 1 Of 2) >> Testing & Repair >> Remove/install and secure rear axle shaft twelve-point collar nut - AR35.30-P-0115-01TX

Remove/install and secure rear axle shaft twelve-point collar nut - AR35.30-P-0115-01TX

WARNING: This page does not describe the selected car, but rather 33 other vehicles, including the 2016 Mercedes-Benz E63 S AMG, 2016 Mercedes-Benz E400, 2016 Mercedes-Benz E350, 2016 Mercedes-Benz E300, and 2016 Mercedes-Benz E250. However, it is still accessible from the selected car via links, so may be relevant.

MODEL 172, 204, 207, 212, 217, 218, 219, 222, 231 

REAR AXLE SHAFT

Number Designation MODEL 219
BA35.30-P-1001-01F Collar nut from rear axle shaft to rear axle shaft flange self-locking Nm 350
not self-locking Stage 1 Nm 170
Stage 2 ∠° 45
REAR AXLE SHAFT

Number Designation MODEL 172 MODEL 204
BA35.30-P-1001-01J Collar nut, rear axle shaft to rear axle shaft flange self-locking Nm 350 350
not self-locking Stage 1 Nm - 170
Stage 2 ∠° - 45
REAR AXLE SHAFT

Number Designation MODEL 207 MODEL 212
BA35.30-P-1001-01J Collar nut, rear axle shaft to rear axle shaft flange self-locking Nm 350 350
not self-locking Stage 1 Nm 170 170
Stage 2 ∠° 45 45
REAR AXLE SHAFT

Number Designation MODEL 218 MODEL 231
BA35.30-P-1001-01J Collar nut, rear axle shaft to rear axle shaft flange self-locking Nm 350 350
not self-locking Stage 1 Nm - -
Stage 2 ∠° - -
REAR AXLE SHAFT

Number Designation MODEL 217 MODEL 222 except CODE Z07
BA35.30-P-1001-01L Collar nut from rear axle shaft to rear axle shaft flange M26x1.5 Nm 350 350
M29x1, 5 nm - -
Fig 1: Securing Rear Axle Shaft Twelve-Point Collar Nut
G10241315Courtesy of MERCEDES-BENZ USA
Fig 2: Locating Rear Axle Shaft Twelve-Point Collar Nut
G10241316Courtesy of MERCEDES-BENZ USA

Detach 

    • 1.1)  MODEL 204, 207, 212, 218, 219

      Apply parking brake.

    • 1.2)  MODEL 172, 217, 222, 231

      Operate electric parking brake (EFB).

  2. Unscrew collar nut (12).

    IMPORTANT The collar nut (12) should be replaced each  time it is unscrewed. If a self-locking collar nut (12) was installed, the thread of the rear axle shaft must be cleaned. Use a suitable brush to remove residues of the thread locking compound (arrow, see Fig 2).

    3. Mount and secure 

    IMPORTANT Note variant of collar nut (12). The non self-locking  variant is replaced by the self-locking variant  .

  3. Tighten collar nut (12).

    IMPORTANT Observe specified tightening torque.

  4. Secure collar nut (12) with caulker to ensure that there is no gap between the groove and locking collar of the collar nut (12).

    IMPORTANT Secure collar nut (12) once.

    • 5.1)  MODEL 204, 207, 212, 218, 219

      Release parking brake.

    • 5.2)  MODEL 172, 217, 222, 231

      Release electric parking brake (EFB).

scientia non olet · About LEMON Manuals