Remove/install radiator grille - AR88.40-P-4001LW
MODEL 205
MODIFICATION NOTES
| 19.2.14 | "Adjustment values" added | Operation step 8 |
Shown with CODE P23 (EXCLUSIVE Exterior) and CODE 5U3 (AIRPANEL)
| Information on preventing damage to electronic components due to electrostatic discharge | AH54.00-P-0001-01A | ||
| Remove/install | |||
| 1 | Remove radiator grille (1) | MODEL 205 with CODE 772 (AMG styling package - front spoiler, side skirts and rear apron) MODEL 205 with CODE 773 (AMG exterior carbon trim package) MODEL 205 with CODE P15 (AVANTGARDE exterior) MODEL 205 with CODE P76 (Standard exterior equipment and appointments) |
|
| AR88.20-P-2050LW | |||
| 2 | Open engine hood | MODEL 205 with CODE P23 (EXCLUSIVE exterior) |
|
| 3 | Remove cable tie (5) | MODEL 205 with CODE P23 (EXCLUSIVE exterior) |
|
| 4 | Disconnect electrical connection (4) | MODEL 205 with CODE 5U3 (AIRPANEL) with CODE P23 (EXCLUSIVE exterior) |
|
| 5 | Disconnect electrical connector (6) | MODEL 205 with CODE 501 (360° camera) with CODE P23 (EXCLUSIVE exterior) |
|
| 6 | Unscrew bolts (2.1 and 2.2) | MODEL 205 with CODE P23 (EXCLUSIVE exterior) |
|
| 7 | Unlock radiator grille (1) from arrests (3) and pull toward front | MODEL 205 with CODE P23 (EXCLUSIVE exterior) |
|
| 8 | Unlock radiator grille (1) from retaining tabs (7) (arrow A) and remove toward front out of bumper (arrow B) | MODEL 205 with CODE P23 (EXCLUSIVE exterior) |
|
| Engine hood to radiator trim/soft nose | *BE60.00-P-1003-01BB | ||
| Protrusion of radiator trim/soft nose, engine hood | *BE60.00-P-1004-01BB | ||
Adjust gap dimensions on radiator grille (1): ↓ Adjust radiator grille (1) |
Figure | ||
| AR88.20-P-2001LW | |||
| 9 | Install in the reverse order | ||
| 10 | Calibrate 360° camera with diagnostic system | MODEL 205 with CODE 501 (360° camera) with CODE P23 (EXCLUSIVE exterior) |
|
| AD00.00-P-2000-04B |
CHECK VALUES FOR GAP DIMENSIONS
| Number | Designation | MODEL 205.0/1 | MODEL 205.2 | ||
|---|---|---|---|---|---|
| BE60.00-P-1003-01BB | Engine hood to radiator trim/soft nose | Dimension "C" | mm | 3, 5 (±1) | 3, 5 (±1) |
| For picture, see | AR60.00-P-0700-01LW | AR60.00-P-0700-01LW | |||
CHECK VALUES FOR GAP DIMENSIONS
| Number | Designation | MODEL 205.0/1 | MODEL 205.2 | ||
|---|---|---|---|---|---|
| BE60.00-P-1004-01BB | Protrusion of radiator trim/soft nose, engine hood | Dimension "C" | mm | 1 (±1) | 1 (±1) |
| For picture, see | AR60.00-P-0700-01LW | AR60.00-P-0700-01LW | |||