Remove/install front SAM control unit - AR54.21-P-1254LW
MODEL 205
MODEL 253
Shown on model 205
| Information on preventing damage to electronic components due to electrostatic discharge | AH54.00-P-0001-01A | ||
| Remove/install | |||
| 1 | Perform initial startup of front SAM control unit (N10/6) | When replacing the front SAM control unit (N10/6). | |
| AD00.00-P-2000-04B | |||
| 2 | Switch off ignition and remove transmitter key | ||
| 3 | Remove left cover below instrument panel | AR68.10-P-1500LW | |
| 4 | Remove driver kneebag | Model 253 with code 294 (Kneebag) |
AR91.60-P-0200LW |
| 5 | Remove bolt (1) | ||
| 6 | Release catch hook (2), move front SAM control unit (N10/6) out of retaining clamps (3) (arrow) and remove far enough from bracket (4) until the electrical connections for the front SAM control unit (N10/6) can be detached | ||
| 7 | Disconnect all electrical connections on front SAM control unit (N10/6) and remove front SAM control unit (N10/6) out of footwell | The number of electrical connectors varies according to vehicle equipment. |
|
| 8 | Install in the reverse order |