Remove/Install Roll Bar Mount - Ar64.20-P-0003LWR

Model 205.4 

Fig 1: Roll Bar Mount, Hardware And Locations (Model 205.4)

Courtesy of MERCEDES-BENZ USA

	Risk of injury  caused by scraping or cutting body parts on sharp vehicle parts	Always wear protective gloves when working on or near sharp and non-deburred vehicle parts. Deburr repair panels.	See AS00.00-Z-0017-01A .
	Remove/install
1	Remove detachable parts in area to be repaired
2	Unscrew bolts (2) on left and right side of vehicle	Bolt, connecting panel to body	See *BA64.10-P-1001-01D .
3	Unscrew bolts (3, 4, 5) on left and right front mounting console (6) and remove mounting consoles (6)	Screw/bolt, mounting bracket to roll bar mount/body	See *BA64.20-P-1002-02A .
4	Unscrew bolts (7) on left and right side of vehicle	Screw/bolt, roll bar mount to longitudinal member	See *BA64.20-P-1001-02A .
5	Remove rollbar mount (1) from vehicle
6	Install in the reverse order

REAR PANEL

Number	Designation		Model 205.4
BA64.10-P-1001-01D	Bolt, connecting panel to body	Nm	20

ROLL BAR MOUNT

Number	Designation			Model 205.4
BA64.20-P-1001-02A	Screw/bolt, roll bar mount to longitudinal member	Stage 1	Nm	18
		Stage 2	Nm	25
		Stage 3		losen ca. 180°
		Stage 4	Nm	25

ROLL BAR MOUNT

Number	Designation		Model 205.4
BA64.20-P-1002-02A	Screw/bolt, mounting bracket to roll bar mount/body	Nm	20