LEMON Manuals: Even more car manuals for everyone
Home >> Mercedes Benz >> 2016 >> C350e >> Repair and Diagnosis >> Accessories & Equipment >> Interior/Illumination Lights >> Electrical System - Body - 205 Chassis - 3 Of 5 >> Retrofitting & Conversion >> Retrofit Front Illuminated Door Sill Molding With Mercedes-Benz Lettering >> Retrofit Front Illuminated Door Sill Molding With Mercedes-Benz Lettering - AZ82.20-P-0005-10LWR

Retrofit Front Illuminated Door Sill Molding With Mercedes-Benz Lettering - AZ82.20-P-0005-10LWR

Model 205.4 

  Information on preventing damage to electronic components due to electrostatic discharge   AH54.00-P-0001-01A
REPAIR MATERIALS

Number Designation Order number
BR00.45-Z-1025-04A Cleaner A 005 989 19 71

IMPORTANT Installation is shown on left side of vehicle as an example. Installation on right side of vehicle is performed analogously.

  1. Clean contact surface of door sill in hatched area with cleaner.
    G12824627Courtesy of MERCEDES-BENZ USA
  2. Remove carrier foils (13) from retaining frame (14).

    IMPORTANT Note guide (15) during installation.

    G13024210Courtesy of MERCEDES-BENZ USA
  3. Position illuminated door sill molding at front left (E17/47) onto longitudinal member and uniformly press on.

    IMPORTANT Observe guides.

  4. Connect black 2-pin connector socket (12) of front left illuminated door sill molding (E17/47) to black 2-pin connector (2.9) of front left illuminated door sill molding branch-off line (2.1).
  5. Clip electrical connector into bracket on cable duct.
  6. Route electrical line of front left illuminated door sill molding (E17/47) over body flange on longitudinal member, and fix in place using duct tape (11).
G13024252Courtesy of MERCEDES-BENZ USA
scientia non olet · About LEMON Manuals