Remove/install sidebag unit in the rear - AR91.60-P-0694LW
MODEL 205.0/2 with CODE 298 (Rear sidebag with belt force limiter)
Shown on model 205.0
| Risk of injury caused by performing testing or repair work on airbag or emergency tensioning retractor units. | Store airbag units with deployment side facing up; do not expose to temperatures greater than 100°C. When working on these units, disconnect the power supply. | AS91.00-Z-0001-01A | |
| Assessment of airbag and belt tensioner units in accident vehicles | AH91.00-P-0006-01B | ||
| Notes on performing repair, body work and welding on vehicles with airbags and RTE units | AH91.00-P-0002-01M | ||
| Information on preventing damage to electronic components due to electrostatic discharge | AH54.00-P-0001-01A | ||
| Legal requirements on handling and storing airbags and emergency tensioning retractor units | AH91.00-P-0004-01A | ||
| Remove/install | |||
| 1 | Remove side paneling (1) | AR68.30-P-4780LW | |
| 2 | Disconnect battery ground line | AR54.10-P-0003LW | |
| 3 | Release and disconnect electrical connector (3) at sidebag unit (2) | ||
| 4 | Unscrew nuts (4) | MODEL 205.0/2 with CODE 298 (Rear sidebag with belt force limiter) |
*BA91.60-P-1005-01O |
| 5 | Remove sidebag unit (2) | ||
| 6 | Dispose of removed sidebag unit (2) properly | When replacing sidebag unit (2). | |
| 7 | Install in the reverse order | ||
| 8 | Connect diagnostic system and check supplemental restraint system (SRS) When replacing sidebag unit (2). | ||
| AD00.00-P-2000-04B |
AIRBAG
| Number | Designation | MODEL 205.0/1/2 | |
|---|---|---|---|
| BA91.60-P-1005-01O | Nut, rear sidebag unit to body | Nm | 6 |