Remove and install cover on rear seat cushion - AR91.18-P-1850LW
MODEL 205.0/1/2 without CODE 248 (Rear seat with integrated child seat) without CODE P10 (Taxi package Germany)
| Remove | |||
| 1 | Remove seat cushion in the rear | AR91.12-P-1020LW | |
| 2 | Remove ISOFIX covers (3) | ||
| 3 | Unhook tension cables (7) and guide through wire hoops (14) | ||
| 4 | Unhook terminal strips (10) | Figure | |
| 5 | Unhook retaining tabs (11) | ||
| 6 | Unhook cover (1) from brackets (arrows) | ||
| 7 | Slip cover (1) over padding (2) | ||
| 8 | Remove wire rings (4) from seat cushion padding (2) using side cutting pliers (8) | Carefully remove residues from wire rings (4). Otherwise, the padding (2) and/or the cover (1) can be damaged. |
|
| 9 | Unclip staple wires (12) from padding (2) | ||
| 10 | Guide reinforcement (13) through right seat belt passage and remove cover (1) from padding (2) | ||
| 11 | Pull staple wires (6, 12) out of cover (1) | When replacing the cover (1). | |
| Install | |||
| 12 | Insert staple wires (6, 12) in new cover (1) | When replacing the cover (1). | |
| 13 | Guide reinforcement (13) through right seat belt passage and align cover (1) over padding (2) | ||
| 14 | Clip in staple wires (12) on padding (2) | ||
| 15 | Attach staple wire (6) with new wire rings (4) to staple wire (5) | ||
| Figure | |||
| 16 | Slip cover (1) over padding (2) and hook into brackets (arrows) | ||
| 17 | Hook in retaining tabs (11) | ||
| 18 | Hook in terminal strips (10) | ||
| 19 | Guide tension cables (7) through wire hoops (14) and hook | ||
| 20 | Hook ISOFIX covers (3) with upper brackets and clip in at bottom | ||
| 21 | Install seat cushion in rear | AR91.12-P-1020LW |