Remove/install panoramic roof front glass roof rubber bellows - AR77.21-P-0530NKB
MODEL 242 with CODE 413 (Panoramic glass roof with top sliding roof)
MODEL 246 with CODE 413 (Panoramic glass roof with top sliding roof)
Shown on left side of vehicle
| Remove/install | |||
| Risk of injury caused by fingers being jammed or pinched when removing, installing or aligning hoods, doors, trunk lid/rear-end door or sliding roof. | No parts of the body or limbs should be within the operating area when the components are moving. | AS00.00-Z-0011-01A | |
| 1 | Move front glass roof (1) to tilt position | ||
| 2 | Remove seal (3) in area of rubber bellows (2) on left and right sides of front glass roof (1) | ||
| 3 | Unclip left and right rubber bellows (2) from catch hooks (arrows) and remove | ||
| 4 | Install in the reverse order |