Remove/Install Front Bumper - Ar88.20-D-2000SE
Model 906 with code ZX8 (Dodge execution) except code XM0 (Facelift)
Model 906 with code ZX9 (Freightliner execution) except code XM0 (Facelift)
| Remove/install | |||
| 1 | Remove front license plate | ||
| 2 | Unscrew screws (2) and remove chrome molding (11) | ||
| 3 | Unclip outside air temperature sensor (B14) from chrome molding (11) | Model 906 with code J65 (Outside temperature sensor) | |
| 4 | Remove radiator grille | AR88.00-D-2115SE | |
| 5 | Unscrew screws (3) and screws (arrows A) | ||
| 6 | Pull cover caps (5) toward front and unclip | MODEL 906 with CODE F46 (Headlamp cleaning system) |
*110589035900 |
| 7 | Remove bolts (6) | *BA88.20-N-1005-01A | |
| 8 | Remove screws (7) | *BA88.20-N-1001-01A | |
| 9 | Unclip left and right fender liner from bumper (1) | ||
| 10 | Slightly pull headlamp surrounds (4) toward front (arrow B), insert detaching tool (8) between corresponding fender (9) and corresponding headlamp surround (4) and unclip headlamp surrounds (4) from fenders (9) | *906589056300 | |
| 11 | Slight pull bumper (1) toward front | ||
| 12 | Disconnect electrical connectors (10) on left and right side of vehicle | Model 906 with code L16 (Front fog lamp, Halogen) |
|
| 13 | Disconnect front bumper PTS connector (X26/27) | Model 906 with code EZ8 (PARKTRONIC) |
|
| 14 | Remove bumper (1) | ||
| 15 | Disassemble bumper (1) | Only if bumper (1) will be replaced. | AR88.20-D-2050SD |
| 16 | Incorporate bore with dimension a = 56 mm, as shown, in center of bumper (1) | Model 906 with code J65 (Outside temperature sensor) Only if bumper (1) will be replaced. | |
| 17 | Install in the reverse order | ||
| 18 | Check/correct headlamp adjustment | ||
| Model 906 except code LG0 (Bi xenon headlamp) except code LG1 (Bi xenon headlamp with cornering lights) | AP82.10-D-8260A | ||
| Model 906 with CODE LG0 (Bi-xenon headlamp) or with CODE LG1 (Bi-xenon headlamp with cornering lights) | AP82.10-D-8260B |
BUMPER
| Number | Designation | MODEL 906 except MODEL 906 with CODE PZ0 | Model 906 | |
|---|---|---|---|---|
| BA88.20-N-1001-01A | Collar screw, front bumper to body | Nm | 25 | 25 |
BUMPER
| Number | Designation | MODEL 906 except MODEL 906 with CODE PZ0 | Model 906 | |
|---|---|---|---|---|
| BA88.20-N-1005-01A | Bolt, front bumper step plate to n crossmember | Nm | 20 | 20 |