Disconnect/Connect Electrical Lines For Removal Of Front Module From Top - Ar88.30-D-1064-02SD

MODEL 906 with ENGINE 642, 651 

Shown on model 906 without CODE XM0 (Model refinement) 

1. Disconnect electrical connector (arrow) and unclip electric wiring harness (3) from front module (4).

   with code (FY1) ATA 2 with interior protection, tow-away protection and rechargeable horn, with code (FZ4) Antitheft alarm system with interior protection and tow-away protection or with code (MJ7) ECO start.

2. Disconnect electrical connector (1) and unclip electric wiring harness (2) from front module (4).

   For code (HH9) Regulated air conditioning, (Tempmatic).

   Courtesy of MERCEDES-BENZ USA

3. Disconnect electrical connector (5) and unclip electric wiring harness (6) from front module (4).

   Not on engine 642 and vehicles with CODE XM0 (Model refinement).

4. Disconnect electrical connector (7) and unclip electric wiring harness (8) from front module (4).
5. Disconnect electrical connectors from left lamp unit (E1) and right lamp unit (E2) or left XENON lamp unit (E16) and right XENON lamp unit (E26).

   Courtesy of MERCEDES-BENZ USA

   Left XENON lamp unit (E1/6) and right XENON lamp unit (E2/6) on model 906 with code (LG0) Bi-xenon headlamp or with code (LG1) Bi-Xenon headlamp with cornering illumination.

6. Disconnect electrical connector (9) from horn and expose electrical wiring harness (10) from front grille (4).

   On engine 642 and vehicles with CODE XM0 (Model refinement).

   Courtesy of MERCEDES-BENZ USA