Prepare Front Longitudinal Member To Passenger Compartment Floor Area - Ar62.20-D-1240-13H

Courtesy of MERCEDES-BENZ USA

The following operation steps are shown on the left component for model 906.733 and must be performed analogously on the right side in the event of damage.

1. Punch Ø 6 mm holes in front longitudinal member (areas A, B, C, D and J).
2. Drill Ø 7 mm holes in front longitudinal member (areas E, F, G, H and I).
3. Grind mating surfaces on front longitudinal member down to bare metal in crosshatched areas.

   Grind spot weld flanges down to bare metal on both sides.

4. Coat insides of spot weld flanges with zinc dust paint.

   Courtesy of MERCEDES-BENZ USA

5. Grind crosshatched areas on front longitudinal member down to bare metal around holes.
6. Grind crosshatched areas on front longitudinal member (1) down to bare metal around holes.

   Courtesy of MERCEDES-BENZ USA