Remove/install cigarette lighter - AR54.10-P-0030RK

MODEL 231 with CODE 301 (Smoker package) 

Fig 1: Cigarette Lighter Remove/Install Components

Courtesy of MERCEDES-BENZ USA

	Remove/install
1	Switch off ignition and remove transmitter key (A8/1) or KEYLESS-GO start/stop button (S2/3) from electronic ignition lock control unit (N73)	KEYLESS-GO start/stop button (S2/3) only with code (889) KEYLESS-GO.
2	Open center armrest and pull out cigarette lighter heating element (2) from housing (4) of cigarette lighter with ashtray illumination (R3)
3	Release housing (4) with pliers (01) and pull out of spring pin (3)	The studs of the pliers (01) must engage in the cutouts (arrows A) of the housing (4). Only pull out enough so that the electrical connector (5) is accessible. Pliers	Fig 2
4	Disconnect electrical connector (5)
5	Unclip spring pin (3) and remove	Check for correct installation position of spring pin (3).
6	Install in the reverse order

Fig 2: Identifying Pliers (169 589 00 37 00)

Courtesy of MERCEDES-BENZ USA