Remove/install front axle level sensors - AR82.10-P-0004LF

MODEL 217 

MODEL 222 

Shown on MODEL 222 

Fig 1: Front Axle Level Sensors Remove/Install Components - Shown On Model 222

Courtesy of MERCEDES-BENZ USA

	Notes on self-locking nuts and bolts		AH00.00-N-0001-01A
	Remove/install
1	Detach complete front wheel
			AP40.10-P-4050HA
2	Disconnect electrical connector (1) at left or right front level sensor (B22/8 or B22/9)
3	Unscrew nut (2) and unhook torsion bar linkage at left or right front level sensor (B22/8 or B22/9)	Do not twist left or right front level sensor (B22/8 or B22/9). Pay attention to installation position. Nut, connecting strut to level sensor	*BA82.10-P-1001-01D
4	Remove screws/bolts (3) and remove left or right front level sensor (B22/8 or B22/9)	Do not bend bracket. Bolt, level sensor to bracket	*BA82.10-P-1003-01D
5	Install in the reverse order
6	Calibrate left or right front level sensor (B22/8 or B22/9) using diagnostic system	When replacing left or right front level sensor (B22/8 or B22/9)
			AD00.00-P-2000-04B
7.1	Check headlamp adjustment	When replacing left or right front level sensor (B22/8 or B22/9)
		MODEL 222	AP82.10-P-8260HA
7.2	Check headlamp adjustment	When replacing left or right front level sensor (B22/8 or B22/9)
		MODEL 217	AP82.10-P-8260S

FRONT AXLE LEVEL SENSOR

Number	Designation		Model 217	MODEL 222
BA82.10-P-1001-01D	Nut, connecting strut to level sensor	Nm	6	6

FRONT AXLE LEVEL SENSOR

Number	Designation		Model 217	MODEL 222
BA82.10-P-1003-01D	Bolt, level sensor to bracket	Nm	6	5