Remove/install eyeglass compartment on roof - AR68.30-P-4400LF

Model 205 (except 205.4) 

Model 217.3, 222 

Shown when removed 

Fig 1: Eyeglass Compartment On Roof Remove/Install Components - Shown When Removed

Courtesy of MERCEDES-BENZ USA

	Remove
1	Remove overhead control panel control unit (1)		AR82.20-P-1000LF
2	Open eyeglasses compartment (2)
3	Remove eyeglasses compartment (2)	For this purpose push eyeglasses compartment (2) to side and unclip at opposite side.
4	Unclip damper (5) from inside toward outside
	Install
5	Insert spring clips (3) on eyeglasses compartment (2) into present groove
6	Install eyeglasses compartment (2)	Insert eyeglasses compartment (2) at one side and clip in on opposite side. Position eyeglasses compartment (2) vertically so that spring clips (3) are positioned on front of retaining pins (4).
7	Check whether spring clips (3) is seated correctly after installing eyeglasses compartment (2)	The spring clips (3) should be seated in front of the retaining pins (4). Otherwise the eyeglasses compartment (2) cannot be opened. If necessary, press spring clips (3) toward front of retaining pins (4) using screwdriver.
8	Close eyeglasses compartment (2)
9	Clip in damper (5) from outside toward inside
10	Install overhead control panel control unit (1)		AR82.20-P-1000LF