Replace rubber mount for compressor - AR32.22-P-2011LF

MODEL 217 

without CODE 487 (MAGIC BODY CONTROL) 

MODEL 222 

without CODE 487 (Active Body Control (ABC)) 

Shown on MODEL 222 

Fig 1: Compressor Rubber Mount Remove/Install Components - Shown On Model 222

Courtesy of MERCEDES-BENZ USA

	Remove
1	Remove AIRmatic compressor (A9/1)		AR32.22-P-2001LF
	Check
2	Check bracket of AIRmatic compressor (A9/1)	In the event of damage or galling on the threaded rods (1), the bracket of the AIRmatic compressor (A9/1) must be replaced ↓ Remove/install bracket for compressor	AR32.22-P-2009LF
3	Push stop buffer (3a) out of eyelet on AIRmatic compressor (A9/1)	Replace stop buffer (3a) and attachment parts on AIRmatic compressor (A9/1). If the stop buffer and (3a) and attaching parts are reused, knocking and thumping noises may occur.
	Assemble
4	Insert stop buffer (3a) in eyelet on AIRmatic compressor (A9/1)	The raised section of the stop buffer (3a) must face downwards. The groove of the stop buffer (3a) must latch all round its total circumference into the eyelet on the AIRmatic compressor (A9/1).
5	Fit shim (3b) onto stop buffer (3a)
6	Slide stop buffer (3c) onto protective sleeve (3d)	The outer lip of the stop buffer (3c) must enclose the washer of the protective sleeve (3d) around its total circumference (arrow).
7	Mount push spring (3e) onto protective sleeve (3d)	The push spring (3e) is centered by a demolding on the stop buffer (3c).
8	Install AIRmatic compressor (A9/1)		AR32.22-P-2001LF