Remove/install lower pendulum support - AR22.10-P-1130NKB

ENGINE 270 in MODEL 242 

ENGINE 270, 607, 651 in MODEL 117 

ENGINE 270, 607, 651 in MODEL 156 

ENGINE 270, 607, 651 in MODEL 176 

ENGINE 270, 607, 651 in MODEL 246 

Shown on model 246 with engine 651 

Fig 1: Lower Pendulum Support Remove/Install Components - Shown On Model 246

Courtesy of MERCEDES-BENZ USA

	Notes on bolted connections with self tapping screws		AH00.00-P-0007-01SF
	Remove/install
1.1	Remove rear part section of bottom section of soundproofing	ENGINE 607 in MODEL 156 ENGINE 607, 651 in MODEL 117, 176, 246
			AR94.30-P-5300NKB
1.2	Remove rear section of lower engine compartment paneling	ENGINE 270 in MODEL 117, 176, 242, 246 ENGINE 270, 651 in MODEL 156
			AR61.20-P-1105NKB
2	Remove screw/bolts (1) for lower torsion bar linkage (2) at support (3)	Bolt, torsion bar linkage at bottom to support for bearing bracket/engine support at bottom	*BA22.10-P-1010-01V
3	Remove screw/bolts (4) for lower torsion bar linkage (2) at front axle carrier (5)	Bolt, torsion bar linkage at bottom to front axle carrier	*BA22.10-P-1011-01V
4	Push engine at oil pan (6) by hand in direction of the front of the vehicle and remove lower torsion bar linkage (2) downwards
	Check
5	Check lower torsion bar linkage (2)	If the lower torsion bar linkage (2) is damaged ↓ Replace torsion bar linkage (2).
6	Install in the reverse order