Notes on operating drawer - AH68.30-P-0001-01A
MODEL 203.0
The drawer load must not exceed 2.5 kg.
Objects that are susceptible to shocks must be stowed in the drawer in such a way that they cannot slide around.
The drawer must always be pushed in up to the limit stop in order to prevent unwanted movements while the vehicle is in operation.
The following must be observed when removing the drawer
:
- Pull out the drawer to the rear limit stop.
- To pull out the drawer beyond the limit stop, push the detent of the left and right drawer lock (6) inward against the spring force and simultaneously pull out the drawer further
The functionality will otherwise not be provided.
The following must be observed when installing the drawer
:
- Push the detent of the left and right drawer lock (6) inward against the spring force, position the drawer in the guide rails (4) and push in up to the front limit stop.
- After approx. 100 mm, the locks engage noticeably in the rear limit stops (7). Only a slight increase in force is required to push the drawer past the stops.
The functionality will otherwise not be provided.
The drawer has a front and rear limit stop. The front limit stop limits how far the drawer can be pushed in; the rear limit stop limits how far the drawer can be pulled out. Attempting to move the drawer beyond the limit stops by applying increased force will damage the drawer. The functionality will otherwise not be provided.