Remove/install side wall lining - AR68.30-P-1450GW

MODEL 463 (except 463.202) as of model year 2013/model refinement package 2012 

Fig 1: Identifying Side Wall Lining Components

Courtesy of MERCEDES-BENZ USA

Fig 2: Identifying Mounting Clamp

Courtesy of MERCEDES-BENZ USA

	Remove/install
1	Remove paneling (2) from rear pillar		AR68.30-P-4505GW
2	Remove rubber door seal in area of side wall paneling (4).
3	Remove rear seat belt	Only remove belt end fitting and upper belt guide fitting.	AR91.40-P-0681GW
4	Press mounting clips (6) on side wall paneling(4) off of door bead	Installation:  Remove mounting clips (6) from side wall paneling (4) and install on door bead, then install side wall paneling (4)
5	Remove side wall paneling (4) from side wall at bottom and rear (arrows)	The side wall paneling (4) is fastened with expansion clips (7) and must be removed carefully. This prevents damage occurring. Installation:  Replace expansion clips (7).
6	Pull side wall paneling (4) out of window seal (5) starting at bottom	Carefully pull out side wall paneling (4). Danger of breakage. Do not damage connections in window antennas
7	Remove side wall lining (4)	The side wall paneling (4) is fastened above with the window with a Velcro strip (8) and inserted below the roof paneling in the front area.
8	Pull belt out of side wall paneling (4)
9	Install in the reverse order