Milling switch opening - AR68.20-P-2030-01B

COMMERCIALLY AVAILABLE TOOLS

Number	Designation
WH58.30-Z-1011-20A	Universal profile milling machine with surface milling cutter (3 single lip miller Ø 5 60mm, 2 single lip miller Ø 5 90mm, templates, fixing supports for model 129, 170, 202, 208, 210, 463), Firma Fetzer GmbH 75446 Wiernsheim-Pinache

Set turntable depth stop (7) on manual router to light colored stop screw (20).
Higher set light colored stop screw (20) for cover with aluminum plate and plastic reinforcement.

Lower set light colored stop screw (24) for wooden cover.

Never readjust the stop screws which are permanently set by the manufacturer, because otherwise the mount would be damaged during operation.

Fig 1: Identifying Light Colored Stop Screws And Turntable Depth Stop
Courtesy of MERCEDES-BENZ USA
Switch on manual router and press down on both handles to stop. Tighten handle.
Smoothly guide manual router in clockwise direction (direction of arrow) along light colored duplicating template on surface of mounting and clamping device. Loosen handle.
Switch off manual router.

Fig 2: Guiding Manual Router
Courtesy of MERCEDES-BENZ USA