Remove/install spring control arm rubber mount - AR35.20-P-0114-01CW

MODEL 204, 207, 212, 218 

Fig 1: Identifying Press Out/In Tool (220 589 01 43 00)

Courtesy of MERCEDES-BENZ USA

Fig 2: Identifying Extraction And Insertion Tool (204 589 04 43 00)

Courtesy of MERCEDES-BENZ USA

Fig 3: Identifying Press (202 589 04 43 10)

Courtesy of MERCEDES-BENZ USA

Removing 

The stroke of the press (010) is very low, because of this the press (010) must be released several times, the spindle (a) of the bracket (01) must be adjusted and the press (010) operated again.

1. Install sleeve (001) on bracket (01).
2. Attach bracket (01) to rear axle carrier (4) and rubber mount (6l) using sleeve (001), thrust piece (04) and press (010).
3. Press rubber mount (6l) out of rear axle carrier (4).
   Fig 4: Spring Control Arm Rubber Mount Remove/Install Components

   Courtesy of MERCEDES-BENZ USA

   Install 

4. Install sleeve (02) on bracket (01).
5. Attach bracket (01) to rear axle carrier (4) and rubber mount (6l) using sleeve (02), thrust piece (07) and press (010).
6. Press rubber mount (6l) into rear axle carrier (4).
   Fig 5: Pressing Rubber Mount Into Rear Axle Carrier

   Courtesy of MERCEDES-BENZ USA