Remove/install radius rod - AR35.20-P-0111EW

MODEL 212, 218, 231 

Fig 1: Radius Rod Remove/Install Components

Courtesy of MERCEDES-BENZ USA

	Risk of death  caused by vehicle slipping or toppling off of the lifting platform.	Align vehicle between vehicle lift columns and position the four support plates at the vehicle lift support points specified by vehicle manufacturer.	AS00.00-Z-0010-01A
	Notes on self-locking nuts and bolts		AH00.00-N-0001-01A
	Notes on repair work on suspension components		AH00.00-P-0100-01A
	Remove/install
1	Lower front rear axle carrier (1)	MODEL 212, 218	AR35.10-P-0015EW
		MODEL 231 with ENGINE 157, 276, 278	AR35.10-P-0016RK
2	Detach strut rod (3) from wheel carrier (7) and rear axle carrier (1)	Self-locking nut, strut rod to wheel carrier	*BA35.20-P-1002-03I
		Self-locking nut, strut rod to rear axle carrier	*BA35.20-P-1001-03I
3	Install in the reverse order

STRUT ROD

Number	Designation				MODEL 212	MODEL 218
BA35.20-P-1001-03I	Self-locking nut, strut rod to rear axle carrier	M12	Stage 1	Nm	50	50
			Stage 2	∠°	90	90

STRUT ROD

Number	Designation				MODEL 231
BA35.20-P-1001-03I	Self-locking nut, strut rod to rear axle carrier	M12	Stage 1	Nm	50
			Stage 2	∠°	90

STRUT ROD

Number	Designation				MODEL 212	MODEL 218
BA35.20-P-1002-03I	Self-locking nut, strut rod to wheel carrier	M12	Stage 1	Nm	50	50
			Stage 2	∠°	90	90

STRUT ROD

Number	Designation				MODEL 231
BA35.20-P-1002-03I	Self-locking nut, strut rod to wheel carrier	M12	Stage 1	Nm	50
			Stage 2	∠°	90