Pull rear axle shaft flange out of angular contact ball bearing - AR35.20-P-0130-06SX

MODEL 172, 204, 207, 212, 217, 218, 222, 231

MODEL 216 (except 216.379)

MODEL 221 (except 221.179) without CODE Z07 (Top protection)

Fig 1: Identifying Puller (211 589 01 33 00)

Courtesy of MERCEDES-BENZ USA

Fig 2: Identifying Press (202 589 04 43 10)

Courtesy of MERCEDES-BENZ USA

Use the following special tools: puller and press (04)

Position support (01) behind rear axle shaft flange (1).
Screw retaining bolts (03) into the rear axle shaft flange (1).
Push guide (05) forwards until the guide pins (02) are fixed in the support (01).
Insert press (04) and pull rear axle shaft flange (1) out of angular contact ball bearing (2) by turning the spindle (arrow).

Fig 3: Pulling Rear Axle Shaft Flange Out Of Angular Contact Ball Bearing
Courtesy of MERCEDES-BENZ USA