Remove/install exhaust line - AR14.20-P-1020-01EWD
ENGINE 272.983 in MODEL 212
HOUSING
| Number | Designation | Transmission 722.9 | ||
|---|---|---|---|---|
| BA27.40-P-1008-01A | Bolt, automatic transmission to engine | M10X40 | Nm | 38 |
| M10X90 | Nm | 38 | ||
| M12 | Nm | - | ||
EXHAUST SYSTEM
| Number | Designation | Engine 156, 157, 271, 272, 273, 276, 278 in model 212 | |
|---|---|---|---|
| BA49.10-P-1040-01AE | Bolt, flange for exhaust gas recirculation lines to exhaust gas recirculation positioner | Nm | 9 |
| BA49.10-P-1041-01AE | Bolt, exhaust gas recirculation line clamp to catalytic converter | Nm | 9 |
Detaching
During remove/install specified sequence must be observed otherwise the exhaust gas recirculation line (1) will be damaged.
- Remove bolt (3) for clamp from exhaust gas recirculation line (1) on catalytic converter and loosen clamp.
- Remove bolt (4) for retaining clamp from exhaust gas recirculation line (1) on transmission.
- Remove bolts (5) on exhaust gas recirculation actuator motors (M16/45) and remove exhaust gas recirculation line (1).
- Attach in reverse order.