Cavity preservation following repair work - AR97.20-P-1500EW

MODEL 212.0/1

Engine hood

Fig 1: Engine Hood Cavity Preservation

Courtesy of MERCEDES-BENZ USA

Liftgate

Fig 2: Liftgate Cavity Preservation

Courtesy of MERCEDES-BENZ USA

Front door

Fig 3: Front Door Cavity Preservation

Courtesy of MERCEDES-BENZ USA

Rear door

Fig 4: Rear Door Cavity Preservation

Courtesy of MERCEDES-BENZ USA

Upper front longitudinal member, A-pillar, B-pillar, C-pillar, side wall paneling and bottom side longitudinal member

Fig 5: Upper Front Longitudinal Member, A-Pillar, B-Pillar, C-Pillar, Side Wall Paneling And Bottom Side Longitudinal Member Cavity Preservation

Courtesy of MERCEDES-BENZ USA

Front longitudinal member

Fig 6: Front Longitudinal Member Cavity Preservation

Courtesy of MERCEDES-BENZ USA

Rear longitudinal member

Fig 7: Rear Longitudinal Member Cavity Preservation

Courtesy of MERCEDES-BENZ USA

Rear end

Fig 8: Rear End Cavity Preservation

Courtesy of MERCEDES-BENZ USA

Under floor

Fig 9: Under Floor Cavity Preservation

Courtesy of MERCEDES-BENZ USA

	Risk of explosion and poisoning caused by solvent vapors and gasses. Risk of injury to skin and eyes when handling anticorrosion agents.	Never spray anticorrosion agents on flames or glowing hot objects and keep them well away from all potential sources of ignition. Use them only in well-ventilated rooms; wear respiratory protection.	AS97.00-Z-0001-01A
	Notes on cavity preservation		AH97.20-P-0001-01B
1	Perform repair preservation	Apply cavity sealant from inside in crosshatched areas following sealing and paintwork, however, before performing assembly work. Apply repair preservation agent twice with a drying time of 5 minutes in between. The spraying hose should be stiff and the nozzles should spray at angle to the front and rear. The cavities should be dry. Insert spray hoses as far as possible into cavities. Spray while inserting and pulling out slowly.
	Processing instructions for cavity preservation agent		AP97.20-P-0640-01A
	Cavity protection, general		GF98.00-P-2045A
		Preservation agent	*BR00.45-Z-1003-05A
2	Remove cavity sealant from drain holes	The processing temperature should not be less than 15 °C. Additional preservation measures may be required, depending on the repair area, deviating from the standard cavity preservation shown.

REPAIR MATERIALS

Number	Designation	Order number
BR00.45-Z-1003-05A	Cavity preservation, solvent-free (1 l container)	A 000 986 72 70 05