Remove/install rear door inner door panel - AR72.12-P-0104EG

MODEL 212 with CODE (Z04) Light armoring with rear power window 

Fig 1: Rear Door Inner Door Panel Remove/Install Components (1 Of 2)

Courtesy of MERCEDES-BENZ USA

Fig 2: Rear Door Inner Door Panel Remove/Install Components (2 Of 2)

Courtesy of MERCEDES-BENZ USA

	Remove/install
	Information on preventing damage to electronic components due to electrostatic discharge		AH54.00-P-0001-01A
1	Completely open crank window
2	Remove rear door lining		AR72.12-P-1010CW
3	Disconnect electrical connector on left rear door (X35/3) or electrical connector on right rear door (X35/4)
4	Unclip grommets (3, 4)
5	Pull door wiring harness (1) out of rear door
6	Release lugs (arrows) on wiring harness bracket (2)
7	Remove line bracket (2) from grommet (3)	Installation position must be observed.
8	Disconnect electrical connectors (5) from left rear door control unit (N69/3) or electrical connectors from right rear door control unit (N69/4)
9	Disconnect electrical connector (6) from left rear door KEYLESS-GO antenna (A2/39) or right rear door KEYLESS-GO antenna (A2/41)	Only on vehicles with code (889) Keyless Go.
10	Disconnect electrical connector (7) from left rear door basic speaker (H4/3h2) or right rear door basic speaker (H4/4h2)
11	Disconnect electrical connector (8) from left rear door pressure sensor (B48/9) and right rear door pressure sensor (B48/10)	Only on vehicles with code (293) right and left rear sidebag.
12	Remove adhesive tape (9) over connector (10) from inner door panel (16)
13	Disconnect electrical connector (10)
14	Separate cable tie (11)	Observe installation position, replace cable tie (11).
15	Cut cable tie (12)	Only on vehicles with code (889) Keyless Go. Observe installation position, replace cable tie (12).
16	Unclip electrical wiring harness from inner door panel (16)	Installation position must be observed.
17	Remove grommets (14, 15, 17, 18) from inner door panel (16)
18	Remove bolts (13)		*BA72.12-P-1006-01O
19	Remove inner door panel (16) from door, simultaneously guide electrical lines, inside door handle Bowden cable and locking pin Bowden cable through
20	Install in the reverse order