Remove/install door frame seal on rear door - AR72.12-P-1015CY

MODEL 204.9 

MODEL 212.0 except CODE (Z04) Light armoring 

MODEL 212.1 

MODEL 212.2 

Shown on model 204.9 

Fig 1: Door Frame Seal On Rear Door Remove/Install Components - Shown On Model 204.9

Courtesy of MERCEDES-BENZ USA

Model 212.0 

Fig 2: Door Frame Seal On Rear Door Remove/Install Components - Shown On Model 212

Courtesy of MERCEDES-BENZ USA

	Removing
1	Wind crank window fully down
2.1	Unclip covers (6) from door lining (11)	Model 204
2.2	Unclip cover (12) from door lining (11) from bottom to top with assembly wedge (9)	Model 212
			Figure
3	Remove bolts (7)
4	Unclip door lining (11) in area of door lock (8) from rear door (5) with assembly wedge (9)	Move assembly wedge directly to mounting clips in door lining (11) and ensure that the retaining tabs on the retaining tabs on the door lining (9) do not tear out of the door lining (11). Unclip door lining (11) until the window frame paneling (10) is accessible.
			Figure
5	Remove window frame paneling (10).
6	Remove door frame seal (1) from rear door (5)
7	Remove glue residues from rear door (5) using surface conditioning disk and clean bonding surface	Bonding surface must be free of grease and dust. Removal disk, Ø 100 mm with fixing shank, 3M Deutschland GmbH D-41453 Neuss Hand drill
		Cleaner	*BR00.45-Z-1025-04A
	Notes on removing adhesive residues and foils on paint and metal surfaces with surface conditioning disks		AH00.00-P-0013-01AK
	Install
8	Loosen spacer strips (2) approx. 2 cm at one end of the new door frame seal (1).
9	Glue on door frame seal (1) to rear door (5) starting at center of door bottom.	The spacer strips (2) on door frame seal (1) should make contact over the entire length with door paneling, without gap
10	Cut off door frame seal protrusion (1) at bottom side of door and connect the two ends of the door frame seal (1).	Cut off protrusion so that there is no gap between the two ends of door frame seal (1). Do not cut off protection at end of door frame seal (1) where the insert (3) protrudes.
11	Firmly roll on door frame seal (1) with roller (4).		Figure
12	Completely remove spacer strips (2) from door frame seal (1) starting at detached end.
13	Install window frame paneling (10).
14	Clip door lining (11) from front door (5)
15	Tighten bolts (7) on door lining (11)
16	Clip in covers (6)	Model 204
17	Clip in cover (12)	Model 212
18	Close crank window

Fig 3: Identifying Mounting Wedge (110 589 03 59 00)

Courtesy of MERCEDES-BENZ USA

Fig 4: Identifying Roller (168 589 05 63 00)

Courtesy of MERCEDES-BENZ USA