Remove/install taillamp - AR82.10-P-4905EL

MODEL 218 

Shown on model 218.3 

Fig 1: Identifying Taillamp Remove/Install Components - Shown On Model 218.3

Courtesy of MERCEDES-BENZ USA

	Remove/install
1	Remove right or left clip (2) and loosen rear center section paneling (1) on the side paneling (3)	MODEL 218.3
2	Loosen side paneling (3) in area of left rear lamp unit (E3) or right rear lamp unit (E4) until nuts (5, 6) are accessible	MODEL 218.3
3	Remove left or right load compartment paneling at rear side	MODEL 218.9
			AR68.30-P-1180ELX
4	Unplug electrical connector (4) from left rear lamp unit (E3) or right rear lamp unit (E4)
5	Unscrew nuts (5, 6)	In order to ensure that left rear lamp unit (E3) or right rear lamp unit (E4) is seated correctly, nut (6) must be tightened at the end.
6	Remove left rear lamp unit (E3) and right rear lamp unit (E4)
7	Install in the reverse order