Component description for electronic overhead control panel - GF82.20-P-5217FQ
MODEL 218 without CODE 414 (Power glass tilting/sliding roof)
Shown without code (350) Ecall Europe emergency call system, gen. 2
Location
The overhead control panel electronics is located at the front, next to the headliner.
Task
The controls for the following systems are arranged at the overhead control panel electronics:
- Interior illumination
- Interior and tow-away protection (with code (882) Interior monitoring (only with ATA))
The node of the wiper/inside rear-view mirror LIN (LIN 2) is integrated in the overhead control panel electronics. The following components are connected to the node:
- Inside rearview mirror (A67) (with code (231) Garage door opener or code (232) Garage door opener with frequency 284-390 MHz, code (249) Automatically dimming inside rearview mirror and outside mirror including folding outside mirrors)
- Rain/light sensor (B38/2)
- Front SAM control unit with fuse and relay module (N10/1)
The overhead control panel electronics are supplied with voltage by the front SAM control unit.
The following components are supplied with voltage by the overhead control panel electronics:
- Rain/light sensor (B38/2)
- Left sun visor mirror lamp (E14/1) via the left front mirror lamp switch (S101)
- Right sun visor mirror lamp (E14/2) via the right front mirror lamp switch (S102)
- Rear dome lamp (E15/3)
The housing of the overhead control panel electronics with code (882) Interior monitoring (only with EDW [ATA]) is also used to accommodate the following components:
- Interior protection and tow-away protection control unit (N26/6)
- Interior protection receiver (N26/6a1)
- Left interior protection transmitter (N26/6b1)
- Right interior protection transmitter (N26/6b2)
- Emergency call system button (S93/3) (with code (350) Ecall Europe emergency call system, gen. 2)
| Wiring diagram for overhead control panel (OCP) control unit | PE54.21-P-2107-97XAB |