Remove/install electric parking brake actuator motor - AR42.20-P-0600NKB
MODEL 117, 156, 176, 242, 246
Shown on MODEL 246
| Notes on self-locking nuts and bolts | AH00.00-N-0001-01A | ||
| Remove/install | |||
| 1 | Switch off ignition and remove transmitter key from electronic ignition lock control unit | ||
| 2 | Unclip electrical lines (3) and unhook from retaining frame (1) | ||
| 3 | Disconnect electrical connector (4) on left electric parking brake actuator motor (M76/1) or right electric parking brake actuator motor (M76/2) | ||
| 4 | Remove screws/bolts (2) and remove left electric parking brake actuator motor (M76/1) or right electric parking brake actuator motor (M76/2) | ||
| *BA42.10-P-1005-12J | |||
| 5 | Convert retaining frame (1) | When replacing the electric parking brake actuator motor (M76/1, M76/2). | |
| 6 | Install in the reverse order | ||
| 7 | Carry out brake test on the test stand | ||
| AP42.00-P-4290BA |
REAR AXLE BRAKE CALIPER
| Number | Designation | MODEL 117 | MODEL 156 | |
|---|---|---|---|---|
| BA42.10-P-1005-12J | Screw/bolt, actuator motor to brake caliper | Nm | 12 | 12 |
REAR AXLE BRAKE CALIPER
| Number | Designation | MODEL 176, 246 | MODEL 242 | |
|---|---|---|---|---|
| BA42.10-P-1005-12J | Screw/bolt, actuator motor to brake caliper | Nm | 12 | 12 |