Drive shaft housing - BA41.50-P-1000-01B
MODEL 190
DRIVE SHAFT HOUSING
| Number | Designation | MODEL 190.3 | |||
|---|---|---|---|---|---|
| BA41.50-P-1001-01B | Bolt, drive shaft housing o engine | M10X45 | Stage 1 | Nm | 20 |
| Stage 2 | ∠° | 90 | |||
| BA41.50-P-1002-01B | Bolt/nut, drive shaft housing to engine | M10X90 | Nm | 40 | |
| BA41.50-P-1003-01B | Bolt, drive shaft housing to transmission | Stage 1 | Nm | 20 | |
| Stage 2 | ∠° | 90 | |||
| BA41.50-P-1004-01B | Bolt, drive shaft to two-mass flywheel | Stage 1 | Nm | 10 | |
| Stage 2 | Nm | 20 | |||
| BA41.50-P-1005-01B | Bolt, compensating ring to drive shaft at rear | Nm | 10 | ||
| BA41.50-P-1006-01B | Bolt, heat shield to drive shaft housing | Nm | 5 | ||