Remove/install trunk lid lock cylinder - AR88.50-P-5061LW
MODEL 205.0/1
| Risk of injury caused by fingers being jammed or pinched when removing, installing or aligning hoods, doors, trunk lid/rear-end door or sliding roof. | No parts of the body or limbs should be within the operating area when the components are moving. | AS00.00-Z-0011-01A | |
| Notes on sensor system for trunk lid opening/closing | AH80.61-P-0001-01A | ||
| Remove/install | |||
| 1 | Remove trunk lid paneling | AR88.50-P-5000LW | |
| 2 | Unhook cable (1) from release (3) | ||
| 3 | Unscrew bolt (2) | ||
| 4 | Turn release (3) in direction of arrow and remove | ||
| 5 | Turn lock cylinder (6) 90° counterclockwise with emergency key (5) | ||
| 6 | Insert pin punch with a diameter of 2 mm into opening (arrow) and release retainer (4) on lock cylinder (6) | ||
| 7 | Pull lock cylinder (6) on emergency key (5) out of release (3) | ||
| Lock cylinder grease spray, 50 ml | *BR00.45-Z-1012-06A | ||
| 8 | Install in the reverse order |
REPAIR MATERIALS
| Number | Designation | Order number |
|---|---|---|
| BR00.45-Z-1012-06A | Lock cylinder grease spray, 50 ml | A 002 989 06 51 |