Adjust front bumper - AR88.20-P-2001LW

Model 205 

Fig 1: Identifying Front Bumper Components - Shown With Code P76

Courtesy of MERCEDES-BENZ USA

Shown with code P76 (Exterior standard equipment) 

	Risk of injury  caused by fingers being jammed or pinched when removing, installing or aligning hoods, doors, trunk lid/rear-end door or sliding roof.	No parts of the body or limbs should be within the operating area when the components are moving.	AS00.00-Z-0011-01A
	Check
1	Check adjustment of front bumper (1)		AR60.00-P-0700-01LW
		Model 205.0/1 Model 205.2 Engine hood to radiator trim/soft nose	*BE60.00-P-1003-01BB
		Model 205.0/1 Model 205.2 Protrusion of radiator trim/soft nose, engine hood	*BE60.00-P-1004-01BB
		Model 205.0/1 Model 205.2 Engine hood to bumper	*BE60.00-P-1005-01BB
		Model 205.0/1 Model 205.2 Bumper to headlamp	*BE60.00-P-1006-01BB
		Feeler gauge	Figure
	Adjust gap dimension
2	Open engine hood (2)
3	Unscrew bolts (3, 4)
4	Unlock front bumper (1) from arrests (5) and pull toward front
5	Close engine hood (2)
6	Adjust front bumper (1) in relation to engine hood (2)	Model 205.0/1 Model 205.2 Engine hood to radiator trim/soft nose	*BE60.00-P-1003-01BB
		Model 205.0/1 Model 205.2 Engine hood to bumper	*BE60.00-P-1005-01BB
		Feeler gauge	Figure
7	Open engine hood (2)
8	Tighten bolts (3, 4)
9	Close engine hood (2)
	Adjust protrusion
10	Switch on ignition	Model 205 with code 5U3 (AIRPANEL) The flaps in the radiator grille open after approx. 120 s.
11	Loosen screw/bolts (6)
12	Adjust front bumper (1) in relation to engine hood (2) and headlamp	Model 205.0/1 Model 205.2Protrusion of radiator trim/soft nose, engine hood	*BE60.00-P-1004-01BB
		Model 205.0/1 Model 205.2Bumper to headlamp	*BE60.00-P-1006-01BB
		Feeler gauge	Figure
13	Fully tighten bolts (6)
14	Adjust headlamps
			AP82.10-P-8260E
15	Calibrate 360° camera with diagnostic system	Model 205 with code 501 (360° camera)
			AD00.00-P-2000-04B

Fig 2: Identifying Feeler Gauge (129 589 03 21 00)

Courtesy of MERCEDES-BENZ USA