Remove/install steering column module - AR54.25-P-2802LW

Model 205, 253 

Shown on model 205 

Fig 1: Identifying Steering Column Module Remove/Install Components - Shown On Model 205

Courtesy of MERCEDES-BENZ USA

Shown on model 205 

Fig 2: Identifying Steering Column Module Remove/Install Components - Shown On Model 205

Courtesy of MERCEDES-BENZ USA

	Information on preventing damage to electronic components due to electrostatic discharge		AH54.00-P-0001-01A
	Remove/install
1	Perform initial startup of steering column tube module (1)	When replacing steering column tube module (1).
			AD00.00-P-2000-04B
2	Move steering wheel all the way to the rear
3	Remove steering wheel		AR46.10-P-0100LW
4	Unclip cover (2) from steering column tube module (1)	Start unclipping at bottom of cover (2).
		Clip remover	Figure
5	Pull steering column tube module (1) off steering column tube	Do not touch red safety catch in steering column tube module (1). Otherwise the clock spring contact will be destroyed. When the steering column tube module (1) is in the correct installation position, the assembly indicator (3) is retracted. When installing a new steering column tube module (1), the transportation lock (7) must be broken off after installation.
6	Remove locking clip (6) from electrical connection (5)	The locking clip (6) is destroyed and must be replaced.
7	Detach the cable duct (4) together with the electrical connection (5) from the steering column tube module (1) and remove steering column tube module (1)
8	Install in the reverse order

Fig 3: Identifying Clip Remover (452 589 01 63 00)

Courtesy of MERCEDES-BENZ USA