Remove/install control unit for TELE AID emergency call system - AR82.95-P-0005LW
MODEL 205.0/1/2 with CODE 348 (Emergency call/assistant system) without CODE ME06 (Hybrid drive 50-KW variant (incl. plugin))
| Risk of injury caused by fingers being jammed or pinched when removing, installing or aligning hoods, doors, trunk lid/rear-end door or sliding roof. | No parts of the body or limbs should be within the operating area when the components are moving. | AS00.00-Z-0011-01A | |
| Information on preventing damage to electronic components due to electrostatic discharge | AH54.00-P-0001-01A | ||
| Notes on sensor system for trunk lid opening/closing | AH80.61-P-0001-01A | ||
| Remove/install | |||
| 1 | Carry out initial startup of emergency call system control unit (N123/4) | When replacing emergency call system control unit (N123/4). | |
| AD00.00-P-2000-04B | |||
| 2 | Switch off ignition and remove transmitter key | ||
| 3.1 | Remove cover in trunk at front | MODEL 205.0/1 with CODE 348 (Emergency call/assistant system) without CODE ME06 (Hybrid drive 50-KW variant (incl. plugin)) |
|
| AR68.30-P-4600LW | |||
| 3.2 | Remove front section of load compartment floor | MODEL 205.2 with CODE 348 (Emergency call/assistant system) without CODE ME06 (Hybrid drive 50-KW variant (incl. plugin)) |
|
| AR68.20-P-4811LW | |||
| 4 | Disconnect electrical connectors (3, 4, 5) | ||
| 5 | Remove bolts (2) | ||
| 6 | Pull out emergency call system control unit (N123/4) towards back from retaining tabs (arrows) at bracket (1) | ||
| 7 | Install in the reverse order |