Removing, installing windowbag - AR91.60-P-0693LW
Model 205.0/1/2
Model 253
Shown on MODEL 205.0
| Risk of injury during testing and repair operations related to pyrotechnical components | Do not expose pyrotechnical components to temperatures above 100°C or 212°C. Disconnect current supply when working on such components. |
AS91.00-Z-0008-01A | |
| Notes on performing repair, body work and welding on vehicles with airbags and RTE units | AH91.00-P-0002-01M | ||
| Information on preventing damage to electronic components due to electrostatic discharge | AH54.00-P-0001-01A | ||
| Information, assessment and legal requirements when working with, handling and storing pyrotechnical components | AH91.00-Z-0000-10A | ||
| Remove/install | |||
| 1 | Move driver seat and front passenger seat into reclining position | Model 205.0/1 | |
| 2 | Disconnect ground line to battery | AR54.10-P-0003LW | |
| 3.1 | Remove headliner and set down on seats | Model 205.0/1 | |
| AR68.30-P-4300LW | |||
| 3.2 | Remove headliner | Model 205.2 Model 253 |
|
| AR68.30-P-4300LWS | |||
| 4 | Release and disconnect electrical connector (5) | ||
| 5 | Unscrew bolt (3) | *BA91.60-P-1004-01O | |
| 6 | Remove cable duct (1) from C-pillar and place to one side with lines routed on inside | Model 205.0/1 | |
| 7 | Remove clamps (4) | ||
| 8 | Unhook shackle (6) at A-pillar | Model 205.0/1/2 | |
| 9 | Unhook gas generator and remove windowbag (2) | ||
| 10 | Dispose of removed windowbag (2) properly | When replacing the windowbag (2). | |
| 11 | Install in the reverse order | ||
| 12 | Connect diagnostic system and check supplemental restraint system (SRS) | Model 205.0/1/2 Model 253 When replacing the windowbag (2). |
|
| Model 205.0/1/2 | AD00.00-P-2000-04B |
AIRBAG
| Number | Designation | Model 205.0/1/2/3 | Model 253 | |
|---|---|---|---|---|
| BA91.60-P-1004-01O | Screw/bolt, window airbag gas generator to roof frame | Nm | 6 | 6 |