Remove/install driver kneebag - AR91.60-P-0200LW

Model 205, 253 with code 294 (Kneebag) 

Fig 1: Identifying Driver Kneebag Remove/Install Components - Shown On Model 205

Courtesy of MERCEDES-BENZ USA

Shown on model 205 

	Risk of injury  during testing and repair operations related to pyrotechnical components	Do not expose pyrotechnical components to temperatures above 100°C or 212°C. Disconnect current supply when working on such components.	AS91.00-Z-0008-01A
	Information on preventing damage to electronic components due to electrostatic discharge		AH54.00-P-0001-01A
	Information, assessment and legal requirements when working with, handling and storing pyrotechnical components		AH91.00-Z-0000-10A
	Remove/install
1	Adjust steering column upward
2	Adjust driver seat to the rear
3	Disconnect battery ground line		AR54.10-P-0003LW
4	Release cover (1) and lower until driver kneebag (3) can be removed		AR68.10-P-1500LW
5	Remove screws/bolts (2) and lower driver kneebag (3) until electrical connector (4) is accessible	Model 205.0/1/2, 253 with code 294 (Kneebag) Screw/bolt, knee airbag to crossmember	*BA91.60-P-1003-01O
6	Disconnect electrical connection (4)	Make sure that electrical connector (4) engages properly.
7	Remove driver kneebag (3)
8	Dispose of removed driver kneebag (3) properly	When replacing driver kneebag (3).
9	Install in the reverse order
10	Connect diagnostic system and check supplemental restraint system (SRS) When replacing driver kneebag (3).
			AD00.00-P-2000-04B