Remove/install right rear seat backrest cover - AR91.18-P-1878LW

MODEL 205.0/1 with CODE 287 (Folding rear seat backrests) 

MODEL 205.2 

Fig 1: Identifying Right Rear Seat Backrest Cover Remove/Install Components - Shown On Model 205.2

Courtesy of MERCEDES-BENZ USA

Shown on model 205.2 

	Remove/install
1	Remove hinge of right backrest with right rear backrest inclination switch		AR91.29-P-1772LW
		Right rear backrest inclination switch can remain on the hinge.
2	Remove head restraint guides		AR91.16-P-1775LW
3	Unclip cover (5) and remove	MODEL 205.2
4	Unhook cover (1) from backrest frame (2) all around the outside	Extraction hook	Figure
5	Guide electrical wiring harness (6) through cover (1)	MODEL 205.2
6	Remove backrest frame (2)	Place backrest frame (2) on padding (3) and align.
7	Slip cover (1) over padding (3) and turn over padding (3)
8	Unclip staple wires (4) from padding (3)
9	Remove cover (1) from padding (3)	Align seams of cover (1) and position in cutouts of padding (3).
10	Pull staple wires (4) out of cover (1)	When replacing the cover (1).
11	Install in the reverse order

Fig 2: Identifying Extraction Hook (140 589 02 33 00)

Courtesy of MERCEDES-BENZ USA