Remove/install restraint systems control unit - AR91.60-P-0624LW
Model 205
| Risk of injury caused by performing testing or repair work on airbag or emergency tensioning retractor units. | Store airbag units with deployment side facing up; do not expose to temperatures greater than 100°C. When working on these units, disconnect the power supply. | AS91.00-Z-0001-01A | |
| Assessment of airbag and belt tensioner units in accident vehicles | AH91.00-P-0006-01B | ||
| Information on preventing damage to electronic components due to electrostatic discharge | AH54.00-P-0001-01A | ||
| Notes on performing repair, body work and welding on vehicles with airbags and RTE units | AH91.00-P-0002-01M | ||
| Remove/install | |||
| 1 | Disconnect battery ground line | AR54.10-P-0003LW | |
| 2 | Remove head unit | Model 205 with code 520 (Audio 20 USB) Model 205 with code 522 (Audio 20 radio) Model 205 with code 531 (COMAND APS) |
|
| AR82.85-P-1100LW | |||
| 3 | Remove foam parts (1) | ||
| 4 | Release and disconnect electrical connectors (2, 3) | ||
| 5 | Unscrew nut (4) | ||
| Notes on the use of paint scraping nuts on ground connections | AH00.19-P-1000-20A | ||
| *BA91.60-P-1007-01O | |||
| 6 | Loosen nuts (5) | ||
| Notes on the use of paint scraping nuts on ground connections | AH00.19-P-1000-20A | ||
| *BA91.60-P-1007-01O | |||
| 7 | Remove supplemental restraint system control unit (N2/10) | ||
| 8 | Install in the reverse order | ||
| 9 | Connect diagnostic system and perform initial startup of supplemental restraint system control unit (N2/10) | When replacing supplemental restraint system control unit (N2/10). | |
| AD00.00-P-2000-04B |
AIRBAG
| Number | Designation | Model 205.0/1/2/3 | |
|---|---|---|---|
| BA91.60-P-1007-01O | Restraint system control unit at vehicle floor | Nm | 10 |