Remove/install front floor covering (left) - AR68.20-P-2050LW

Model 205 

Model 253 

Fig 1: Identifying Front Floor Covering (Left) Remove/Install Components

Courtesy of MERCEDES-BENZ USA

	Remove/install
1	Adjust steering column toward rear and completely upward
2	Move the left front seat completely to the rear	Model 205
3	Release front seat and tilt backwards	Model 253
			AR91.10-P-1000LW
		Do not disconnect electrical connectors.
4	Switch off ignition and remove transmitter key
5	Unscrew front bolts from guide rails on front seat	Model 205
		Bolt, front seat to vehicle floor	*BA91.10-P-1001-01T
6	Remove cover below left of instrument panel		AR68.10-P-1500LW
7	Remove accelerator pedal (3)		AR30.12-P-1321LF
8	Remove door sill molding (2)	Model 205.0/1/2 Model 253	AR68.30-P-4100LW
9	Remove floor covering (1) from front to rear	Removal:  Use assembly wedge in center console area. Position floor covering (1) below center console.
		Mounting wedge	Figure
10	Install in the reverse order

FRONT SEATS

Number	Designation		Model 205
BA91.10-P-1001-01T	Bolt, front seat to vehicle floor	Nm	50

Fig 2: Identifying Mounting Wedge (110 589 03 59 00)

Courtesy of MERCEDES-BENZ USA