Reversing camera control unit, component description - GF54.65-P-5030CEJ
MODEL 204.0/2 with CODE (218) Backup camera with CODE (498) Japan version as of Model Year 2009 /CY 08
MODEL 204.3, 204.9 up to 31.5.12 with CODE (218) Backup camera with CODE (498) Japan version
Shown on model 204.2
Location
The reversing camera control unit is located on the left side of the trunk behind the panel.
Task
The reversing camera control unit has the following tasks:
- Reading in of signals
- Evaluation of input factors
- Actuation of components
Reading in of signals
The input factors are read in via the following connections:
- Direct line
- Interior CAN (CAN B)
Direct line
The following components are read in via a direct line:
- Reversing camera (B84/3)
- Front passenger outside mirror camera (B84/5) (on model 204.9)
Interior CAN
The signals are read in by the reversing camera control unit over the interior CAN.
The functions that use these signals are described in the individual function descriptions (see block diagram or function schematic).
Evaluation of input factors
The input factors that have been read in are evaluated by the integrated microprocessor and the relevant components are then actuated.
Actuation of components
Components are actuated with the following connection:
- Direct line
Direct line
The following components are actuated via a direct line:
- COMAND controller unit (A40/3)
- Backup camera
- Front passenger outside mirror camera (on model 204.9)
| Wiring diagram for backup camera control unit | PE54.65-P-2102-97FAA |