Remove/install pressure transducer for boost pressure control - AR07.17-P-7002RKB
ENGINE 157, 278 in MODEL 231
| Remove/install | |||
| Risk of injury caused by fingers being jammed or pinched when removing, installing or aligning hoods, doors, trunk lid/rear-end door or sliding roof. | No parts of the body or limbs should be within the operating area when the components are moving. | AS00.00-Z-0011-01A | |
| Notes on avoiding damage through contamination and foreign objects | AH00.00-P-5000-01A | ||
| 1 | Open engine hood | ||
| 2 | Remove center section of the upper engine cover (1) | ||
| 3 | Remove vacuum lines (2) from boost pressure control pressure transducer (Y77/1) | ||
| 4 | Disconnect electrical connection (3) at boost pressure control pressure transducer (Y77/1). | ||
| 5 | Remove boost pressure control pressure transducer (Y77/1) | *BA09.41-P-1009-01O | |
| 6 | Install in the reverse order | ||
| 7 | Read out fault memory with STAR DIAGNOSIS and clear if necessary | ||
| Connect STAR DIAGNOSIS and read out fault memory | AD00.00-P-2000-04A |
CHARGE AIR PIPE/CHARGE AIR COOLING
| Number | Designation | ENGINE 157 | ENGINE 278 | |
|---|---|---|---|---|
| BA09.41-P-1009-01O | Bolt, pressure transducer to bracket | Nm | 7 | 7 |