Remove/install desiccant cartridge - AR83.30-P-6521LF
MODEL 217
MODEL 222
Shown on MODEL 222
Shown on MODEL 217 with CODE 610 (Night View Assist Plus) and CODE P20 (Driving Assistance Package Plus)
| Remove | |||
| 1 | Drain air conditioning system | AR83.30-P-1760LF | |
| 2 | Remove sealing (2) | ||
| 3 | Remove engine intake air ducts (3) | MODEL 217 MODEL 222 With engine 276.9, only one engine air intake duct (3) is installed. |
|
| 4.1 | Remove bumper | MODEL 217 | AR88.20-P-2000LC |
| 4.2 | Remove radiator grille | MODEL 222 | AR88.40-P-4001LF |
| 5 | Open retaining clip (5) and unhook hood release cable (4) from carrier reinforcement (1) | ||
| 6 | Disconnect electrical connector (7) from front long range radar sensor (B29) | MODEL 217 with CODE P20 (Driving Assistance package Plus) MODEL 222 with CODE P20 (Driving Assistance package Plus) |
|
| 7 | Disconnect electrical connector (7.1) from infrared camera (B84/11) | MODEL 217, 222 with CODE 610 (Night View Assist Plus) |
|
| 8 | Unclip spray nozzle (18) from infrared camera (B84/11) | MODEL 217, 222 with CODE 610 (Night View Assist Plus) |
|
| 9 | Remove screw/bolt (6) from carrier reinforcement (1) | ||
| 10 | Remove carrier reinforcement (1) with upper radiator guides (17) | ||
| 11 | Unscrew drier cap (8) | ||
| 12 | Remove circlip (9) | ||
| 13 | Screw in screw/bolt M12 into drier head (11) and pull out drier head (11) | ||
| 14 | Remove drier module bracket (16) | ||
| Install | |||
| 15 | Check packaging of new desiccant bag (13) for damage | If damaged: ↓ Dispose of new desiccant bag. |
|
| 16 | Apply new desiccant bag (13) on drier module riser line (12) | ||
| 17 | Install drier module bracket (16) with new desiccant bag (13) | ||
| 18 | Remove screw/bolt M12 from drier head (11) | ||
| 19 | Install retaining ring (9) | ||
| 20 | Screw in drier cap (8) | ||
| 21 | Install carrier reinforcement (1) with upper radiator guides (17) | ||
| 22 | Screw screw/bolt (6) into carrier reinforcement (1) | ||
| 23 | Clip in spray nozzle (18) of infrared camera (B84/11) | MODEL 217 with CODE 610 (Night View Assist Plus) MODEL 222 with CODE 610 (Night View Assist Plus) |
|
| 24 | Connect electrical connector (7.1) of infrared camera (B84/11) | MODEL 217 with CODE 610 (Night View Assist Plus) MODEL 222 with CODE 610 (Night View Assist Plus) |
|
| 25 | Connect electrical connector (7) of front long range radar sensor (B29) | MODEL 217 with CODE P20 (Driving Assistance package Plus) MODEL 222 with CODE P20 (Driving Assistance package Plus) |
|
| 26 | Close retaining clip (5) and clip hood release cable (4) into carrier reinforcement (1) | ||
| 27.1 | Install radiator trim | MODEL 222 | |
| 27.2 | Install bumper | MODEL 217 | |
| 28 | Install engine air intake ducts (3) | MODEL 217 MODEL 222 |
|
| 29 | Install sealing (2) | ||
| 30 | Charge air conditioning system | AR83.30-P-1760LF | |
| 31 | Perform initialization of long range radar sensor at the front (B29) using a diagnostic system | MODEL 217 with CODE P20 (Driving Assistance package Plus) MODEL 222 with CODE P20 (Driving Assistance package Plus) |
|
| AD00.00-P-2000-04B | |||
| 32 | Check air conditioning for proper operation |