Cavity preservation following repair work - AR97.20-P-1500LF

MODEL 217, 222

The following differentiation is made for cavity preservation:

Fig 1: Crimping Area Cavity Preservation, Inner Surface, Cavities And Gaps

Courtesy of MERCEDES-BENZ USA

Engine hood, shown on model 222.0

Fig 2: Engine Hood Cavity Preservation Area - Shown On Model 222.0

Courtesy of MERCEDES-BENZ USA

Liftgate, MODEL 222.0

Fig 3: Liftgate Cavity Preservation Area - Shown On Model 222.0

Courtesy of MERCEDES-BENZ USA

Front fender, shown on MODEL 222.0

Fig 4: Front Fender Cavity Preservation Area - Shown On Model 222.0

Courtesy of MERCEDES-BENZ USA

Front door, shown on MODEL 222.0

Fig 5: Front Door Cavity Preservation Area - Shown On Model 222.0

Courtesy of MERCEDES-BENZ USA

Rear door MODEL 222.0

Fig 6: Rear Door Cavity Preservation Area - Shown On Model 222.0

Courtesy of MERCEDES-BENZ USA

Front longitudinal member, shown on model 222.0

Fig 7: Front Longitudinal Member Cavity Preservation Area - Shown On Model 222.0

Courtesy of MERCEDES-BENZ USA

Upper front longitudinal member, A-pillar, B-pillar, C-pillar, side wall paneling and bottom side longitudinal member, shown on MODEL 222.0

Fig 8: Longitudinal Members (Upper Front/Bottom Side), Pillars (A/B/C) And Side Wall Paneling - Shown On Model 222.0

Courtesy of MERCEDES-BENZ USA

Rear longitudinal member, shown on model 222.0

Fig 9: Rear Longitudinal Member - Shown On Model 222.0

Courtesy of MERCEDES-BENZ USA

Rear area, shown on model 222.0

Fig 10: Rear Area - Shown On Model 222.0

Courtesy of MERCEDES-BENZ USA

Underfloor, shown on model 222.0

Fig 11: Underfloor Cavity Preservation Area - Shown On Model 222.0

Courtesy of MERCEDES-BENZ USA

Picture no., etc.	Work notes
	Risk of explosion and poisoning caused by solvent vapors and gasses. Risk of injury to skin and eyes when working with anticorrosion agents	Never spray corrosion protection on flames or hot, glowing objects and keep them well away from all potential sources of ignition. Use them only in well-ventilated rooms; wear respiratory protection.	AS97.00-Z-0001-01A
	Notes on cavity preservation		AH97.20-P-0001-01B
A	Cavity preservation in crimping area	MODEL 217 Cavity preservation is not required for liftgate consisting of plastic. MODEL 222 Install from inside through openings (arrows) with hook probe. Apply cavity preservation with spraying hose and nozzle (spraying angle 360°) as far as possible into cavities. Cavity preservation, solvent-free (1 l container)	*BR00.45-Z-1003-05A
B	Inner surface, cavities and gaps	MODEL 217 Cavity preservation is not required for liftgate consisting of plastic. MODEL 222 Uniformly moisten cavity preservation. Cavity preservation, solvent-free (1 l container)	*BR00.45-Z-1003-05A

REPAIR MATERIALS

Number	Designation	Order number
BR00.45-Z-1003-05A	Cavity preservation, solvent-free (1 l container)	A 000 986 72 70 05