Wiring diagram for common rail diesel injection (CDI) control unit - PE07.16-P-2101-97DAE
WARNING: This page does not describe the selected car, but rather 33 other vehicles, including the 2016 Mercedes-Benz E63 S AMG, 2016 Mercedes-Benz E400, 2016 Mercedes-Benz E350, 2016 Mercedes-Benz E300, and 2016 Mercedes-Benz E250. However, it is still accessible from the selected car via links, so may be relevant.
ENGINE 651 up to 5/31/10 in MODEL 212 (except 212.08/09/28/29) except CODE U42 (BlueTEC diesel exhaust treatment (SCR)) Control unit N3/9, vehicle connector
| Code: | Designation: | Position: |
|---|---|---|
| A0 | Color code key | 80L |
| B19/9 | Temperature sensor upstream of diesel particulate filter | 63L |
| B28/8 | Differential pressure sensor (DPF) | 65L |
| B37 | Accelerator pedal sensor | 57L |
| B79/2 | Transmission neutral position sensor | 68L |
| CAN C | Drive train CAN | 10K |
| CAN E | Chassis CAN | 14K |
| Code 474 | Diesel particulate filter | 61F |
| F32 | Front electrical prefuse box | 52L |
| F32f153 | Prefuse 153 | 51K |
| G3/2 | Oxygen sensor upstream of catalytic converter | 17L |
| G3/2x1 | Electrical connector for oxygen sensor upstream of catalytic converter | 16J |
| M1 | Starter | 45L |
| M4/7 | Combustion engine and air conditioning with integrated control fan motor | 55L |
| N10/1 | Front SAM control unit with fuse and relay module | 21L |
| N10/1 | Front SAM control unit with fuse and relay module | 27L |
| N10/1 | Front SAM control unit with fuse and relay module | 33L |
| N10/1 | Front SAM control unit with fuse and relay module | 38L |
| N10/1f22 | Fuse 22 | 24L |
| N10/1f22 | Fuse 22 | 36L |
| N10/1f23 | Fuse 23 | 26L |
| N10/1f23 | Fuse 23 | 35L |
| N10/1f24 | Fuse 24 | 37L |
| N10/1f27 | Fuse 27 | 23L |
| N10/1f6 | Fuse 6 | 20L |
| N10/1f7 | Fuse 7 | 33L |
| N10/2 | Rear SAM control unit with fuse and relay module | 7L |
| N118 | Fuel pump control unit | 3L |
| N2/10 | Supplemental restraint system control unit | 48L |
| N3/9 | CDI control unit | 5A |
| N3/9 | CDI control unit | 12A |
| N3/9 | CDI control unit | 20A |
| N3/9 | CDI control unit | 28A |
| N3/9 | CDI control unit | 36A |
| N3/9 | CDI control unit | 44A |
| N3/9 | CDI control unit | 52A |
| N3/9 | CDI control unit | 60A |
| N3/9 | CDI control unit | 69A |
| S40/3 | Clutch pedal switch | 60L |
| S40/5 | Start enable clutch pedal switch | 70L |
| U12 | Valid for left-hand drive vehicles | 60F |
| U13 | Valid for right-hand drive vehicles | 60G |
| U24 | Valid for manual transmission | 59E |
| U24 | Valid for manual transmission | 66E |
| U245 | Valid for fuel system control unit | 1F |
| U246 | Valid without fuel system control unit | 5F |
| U252 | Valid for ECO start/stop function | 66E |
| W15/1 | Right footwell ground point | 60H |
| W15/2 | Left footwell ground point | 60H |
| W15/2 | Left footwell ground point | 70H |
| W16/6 | Right major assembly compartment ground point | 16E |
| W9 | Left front ground point (at lamp unit) | 55H |
| X220 | New Manual Transmission zero position sensor electrical connector | 67H |
| X25/2 | Engine compartment/interior electrical connector | 55E |
| X26 | Interior and engine wiring harness electrical connector | 41H |
| X26 | Interior and engine wiring harness electrical connector | 62H |
| X30/21 | Drive train CAN voltage distributor electrical connector | 11L |
| X30/30 | Vehicle floor chassis CAN voltage distributor electrical connector | 14L |
| Y84 | Radiator shutters actuator | 39L |
| Z51/19 | Engine management crash signal connector sleeve | 48E |
| Z6/8 | Sensor ground connector sleeve | 64E |
| Z7/35 | Circuit 87 M1e connector sleeve | 25E |
| Z7/36 | Circuit 87 M2e connector sleeve | 65E |